SOLID SURFACE EDGES INSTALLATION

router
Step 1
Laminate deck and finish trim with router and straight edge.
saw
Step 2
Pre-cut KUEHN Bevel Molding longer than edge to be covered, using a 60 tooth carbide tipped blade or solid surface blade in trim saw or table saw.
sand
Step 3
Fit molding. Sand in mitres and joints with disc sander equipped with mitre fence.
cut_slots
Step 4
Cut biscuit slots (minimum of 12″ apart). Insert “O” biscuit. If preferred, a 5/32″ slotter cutter can be used.
prefit
Step 5
Pre-fit all pieces prior to gluing.
seal
Step 6
Apply adhesive sealant over ENTIRE back surface of molding to assure a good watertight seal.
tape
Step 7
Affix molding using filament tape every 2″-3″. Align top edge of molding precisely with edge of the laminate while taping. Scrape off excess adhesive sealant. Let adhesive sealant dry before removing tape. (24 hours is recommended before removing tape.)
finish
Step 8
It’s that easy to install KUEHN Bevel Solid Surface Edges! 1-800- TO BEVEL

NOT RECOMMENDED for use in FABRICATION of Solid Surface Countertops where a color match must be achieved. Recommended Adhesive/Sealant manufactured by Eclectic Products, Inc. available from KUEHN Bevel.

Find Kuehn Bevel Near You
Join the
Kuehn Bevel
family of
the finest
craftsmen in
the country.
1-800-TO-BEVEL (800-862-3835) JOIN OUR NETWORK